Chocolate mold car VW Beetle

Chocolate mold car VW Beetle

Chocolate figurines are perfect gifts. At Easter, chocolate Easter bunnies line the shelves of major distributors and in the run-up to Christmas, hundreds of chocolate Samichläuse are sold. As an alternative to the Samichläuse and bunnies or simply as a special gift for a VW Beetle fan, this chocolate car is particularly suitable.

Chocolate mold - application

Preparation

For all molds used to pour chocolate molds, preparation is extremely important. Rinse the mold with lukewarm water and a gentle rinsing agent. This must not contain lye or rinse aid, as this would corrode the molds. Then rinse off all residues with lukewarm water and dry the mold very well. From now on, do not touch the mold directly, otherwise fingerprints will be visible on the chocolate later. Hold the mold at the edge where no chocolate will be poured later. Polish the mold with a non-fibrous absorbent cotton or a very fine handkerchief.

You should use only high quality tempered couverture for making chocolate figures. Chocolate from the supermarket does not become liquid enough and does not otherwise produce the desired quality. For tempering, it is best to use a tempering device, but you can also make a water bath. Be careful not to let any water get into the chocolate. This would cause the chocolate to become crumbly and clump together.

Make up

Now you can start with the make-up. You can use colored cocoa butter or tempered couverture for this purpose. You can also color white couverture with fat-soluble powder colors for chocolate. For a beige coloring, mix 1/3 milk couverture with 2/3 white couverture. For this, both couvertures must be tempered and not mixed for too long, otherwise they will cool down considerably.

Take out the tempered couverture or a little melted cocoa butter and start with the outermost layer. Chocolate molds must be painted from the outside in, which means that what is painted first will later be visible from the outside. The best way to apply the compound is with a fine brush, a sponge or by hand. It is important that all materials are clean, dry and free of grease. If you want to draw a pattern with your fingers, be sure to wear plastic gloves. Otherwise, your fingerprints will be visible later. Once the couverture or cocoa butter has dried slightly, apply the next layer. This is how you keep working your way inward. While you are making up, you can turn your mold over from time to time. This way you can see what your final product will look like.

Pouring and finishing the mold

Once you are satisfied with all the colored details, give it another quick tighten. Then take a larger brush. Use it to brush the entire mold with couverture. Use the color of the couverture that you want your product to have in the end. Turn the mold over and over again. No more air bubbles should be visible, otherwise they would be visible as holes in the finished mold. Use a metal horn to remove chocolate from the surface of the mold. Now fill the mold with some couverture. It is best to use a soup ladle for this. Then place the second half of the mold on the filled mold and secure it with the metal clamps. Now tilt and turn the mold until the couverture is nicely distributed and put the mold in the refrigerator for 15 to 20 minutes. Then you can take out the mold and carefully release the VW Beetle.